ep

February 13, 2020

Capacity
All power take-offs are specifically designed for traveling hydraulic pumps to SAE J744C series ‘B’ specification with splined input shaft and either two-bolt or four-bolt fixing. The utmost power which may be transmitted can be 22 KW (29.5 bhp) per 1000 rev/min engine speed; this compatible a torque of 209 Nm (155 Ibf.ft. – 21.33 kgm.).For PRM1000 the clutched power take-off provides pump rotation the same as the engine, where as the direct drive power take-off for the PRM500 and PRM750 will give opposite rotation. Power to the pump is not affected by the standard use of the gearbox for propulsion responsibilities. All ancillary power circuits powered by PRM power take-offs ought to be designed relative to the recommendations of the hydraulic tools manufacturer, and should be correctly safeguarded against overloading.
Installation
PRM power take-off products fit on the trunk face of the primary gearcase and so are driven by the insight shaft; consequently they may be operated at all times whilst the engine can be running, The energy take-off replaces the end cover which is normally installed and performs the functions of the end cover by sealing the gearbox against lack of oil and correctly positions the insight shaft rear bearing. Power take-off devices provide the link between your gearbox and the hydraulic pump.

Direct Drive Power Take-Off
On the PRM500 and PRM 750 the immediate drive power take-off can be driven directly from the gearbox insight shaft; consequently it’ll operate all the time when the engine can be running, and since there is absolutely no clutch for disengagement of the hydraulic pump, provision should be manufactured in the auxiliary hydraulics circuits for pressure by-move to the reservoir when capacity to the pump is not needed. A pair of 1:1 ratio gears, providing adequate offset between the gearbox output shaft and the centreline of the energy take-off to make sure there is sufficient clearance between your hydraulic pump and propeller shaft coupling.

Specifications
Ever-Power PTO Shaft
Series 6
1-3/8 inch 6-spline tractor end yoke and a 1-3/8 inch 6-spline FD2 clutch on the implement end
FD2 clutch
Collapsed length: 47 in.
Extended length: 60 in.
62 HP at 540 RPM
98 HP at 1000 RPM
FD2 clutch attaches with one bolt that fits a groove on insight shaft of rotary mower

Would like to know about pto gearbox? Please see the website.