one.A connecting hyperlink of an O-ring Chain for common application is pre-coated with grease at the pins. Before connection, confirm the grease over the surfaces of pins, and when the volume of grease is tiny, apply grease with bare hands. (If gloves are applied, the grease will probably be absorbed through the gloves.)
Illustration: Once the connecting link (I) of an O-ring chain for standard application is
shipped, O-rings are fitted in the roots of your pins. When the O-rings come loose because of vibration throughout transport, refit the O-rings in for the roots with the pins.
In this case, make sure to return the grease collected at the roots in the pins to your central surfaces with the pins, a lot more at portion A than at portions B shown in the above illustration. (Portions A is worn as a result of sliding with all the bushings.)
2.The chain can be most conveniently linked over the teeth of a sprocket. Engage the back links at the two ends of the chain using the sprocket teeth and match connecting pins. Should the sprocket can be moved, the chain may also be connected over the loosened side.
3. Connecting method
1.Confirm that O-rings are attached to your roots from the pins.
2.Should the amount of grease applied on the connecting pins is small, coat the pins with grease with the central portions.
three.Insert the connecting pins into the bushings in the inner backlinks at both ends.
four.Confirm the grease is applied towards the entire face of your O-ring, and fit the O-ring onto the connecting pins.
5.Insert the connecting pins in to the connecting plate and whilst pressing the connecting plate, set up the spring clip. Verify no matter whether the head (the finish without a split) of the spring clip is turned while in the feeding route with the chain. (See the following illustration.)
six.Make sure you verify that the spring clip is securely fitted inside the clip grooves with the connecting pins.
This completes jointing of your connecting website link. Note that grease within the surfaces of connecting pins and O-rings may be removed throughout installation work. In this instance, re-grease using the grease about the surface from the base chain or even the grease within the polyethylene bag by which the connecting hyperlink was contained.