Power UNITS FOR LIFT TABLE one
Standard Description
This energy unit is created solely for the tiny lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This energy unit is widely applied during the marketplace of logistic devices for instance minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is controlled by the solenoid valve with the pace managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Common Description
This electrical power unit is intended exclusively for your medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve as well as the speed managed through the adjustable needle valve. Once the lift rises to a substantial positoin, however the electrical power provide is reduce, the decreasing motion is controlled through the guide override perform.
Power UNITS FOR LIFT TABLE three
Common Description
This energy unit is designed solely for the large lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as velocity managed by a pressure compensated flow handle valve.
Power UNITS FOR LIFT TABLE four
General Description
This energy unit is built exclusively for the significant lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve and also the pace managed from the adjustable needle valve. Once the lift rises to a high positoin, but the power supply is lower, the decreasing movement is managed from the guide override function.
Particular Notes
one. This electrical power unit is of S3 duty cycle, which might only function intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all of the hydraulic components concerned before set up of the power unit.
three. Viscosity of the oil shoud be 15~46 cst,which should really also be clean and free of impurities.N46 hydraulic oil is suggested.
4. Oil changing is needed after the original one hundred operation hours,afterwards once each and every 3000 hours.
5. The energy unit proven is made to be mounted vertically.